WRAP-UP Next 0566-FD - Pitch Checker Attachment for Caliper

WRAP-UP Next - 0566-FD - Pitch Checker Attachment for Caliper

Support the accurate setting. To take the dimension of parts too. Attachment Tool that can accurately measure the center of the hole just by mounting it to the tino.

It is an attachment tool that can accurately and speedy measurement between the center of the hole that has been difficult until now. You can measure the hole diameter by making the tip of the tip. If you take the dimension of parts and install a pillow ball on the other side of the screw section, you can also do the adjustment of the turn buckle while looking at the numbers. Responding to most of the aftermarket. This is a recommended tool that you can use regardless of category. Made of Steel (2 PCS 1 pairs)

The view of the numbers when installing digital no

■ installing pitch checker after reset the counter
The number displayed is the correct value.

■ Reset the counter after installing the pitch checker
10 mm plus the correct value from the shown number
If you install a pillow ball, etc. On the other side of the 3 mm screw hole, you can also do the turn buckle adjustment while checking the numbers. (please change your attachment to imo screws. ()

* Digital caliper is NOT included. Its available separately